User`s manual

Chapter 6 133
Advanced Operations
Status Reporting
Operation Status Register Group
The Operation Status Register Group contains information about the
state of the measurement systems in the Test Set. This status group is
accessed using the STATus commands. The Operation Status Register
Group uses 16-bit registers and includes a Condition Register,
Transition Filters, an Event Register, an Enable Register, and a
Summary Message. Refer to the “Status Register Structure Overview”
on page 127 for a discussion of status register operation. Figure 6-6
shows the structure and STATus commands for the Operation Status
Register Group.
Figure 6-6 Operation Status Register Group
0
:STATus: OPERation: ENABle
?
<integer>
:STATus: OPERation: EVENt ?
:STATus: OPERation
:PTRansition
:NTRansition
?
<integer>
?
<integer>
:STATus: OPERation: CONDition ?
Summary
Message
Bit
Condition
Register
Transition
Filter Registers
Event
Register
Enable
Register
1
2
3
4
5
6
7
8
9
10
11
12
13
14
L
o
g
i
c
a
l
O
R
15
(to bit 7 of Status
Byte Register)
ch4drw06.drw