User`s manual

Chapter 4 101
IEEE Common Commands
Common Command Descriptions
*SAV (Save Instrument State)
The *SAV command saves the present state of the Test Set into a file in
battery-backed internal memory or on a PC card. The *SAV command is
followed by a decimal number in the range of 0 to 99 which indicates
the name of the stored SAVE/RECALL file. The mass storage location
for SAVE/RECALL files is selected using the SAVE/RECALL field on the
I/O CONFIGURE screen.
The *SAV command cannot be used to save the present state of the Test
Set to a file with a name which contains non-numeric characters or a
decimal number greater than 99. To save the present state of the Test
Set to a file with a name which contains non-numeric characters or a
decimal number greater than 99, use the REG:SAVE filename
command.