Specifications

64 Chapter 3
Troubleshooting
Functional Diagnostics (Step 2)
Configuring a Printer
Only perform the following steps if you want to print test results to a
printer.
1. If you are not already at the SOFTWARE MENU screen, press the
Menu key.
2. Under SET UP TEST SET:, select Print to access the “TESTS
(Printer Setup)” screen.
3. Under PRINT SETUP:, select Model: and the printer of your choice.
4. Set the Printer Port: for the side-panel connector your printer is
connected to (Parallel 15, Serial 9, or GPIB).
If an GPIB printer is used, you need to enter the printer’s two-digit
bus address when the Printer Adrs field appears (Example; enter 1
or 01 for bus address 701). Also, press the
Shift key, then the INST
CONFIG key to access the I\O CONFIGURE screen, and set the Mode
field to Control.
5. Under PAGE CONTROL:, set the Lines/Page: and Form Feed (FF at
Start:, and FF at End:) parameters if necessary.