User`s guide

41
GPIB Commands
Example
460 PAUSE
470 !
480 !
490 !
500 ! Setup the Mobile’s IMSI and then page the mobile
510 !
520 OUTPUT Addr;”MSINfo:PAGing:IMSIdentity “;Imsi$
530 DISP “Paging Mobile...”
540 OUTPUT Addr;”CELL:CALL:ORIG”
550 !
560 !
570 !
580 ! Go around a loop until the call is connected
590 !
600 Times=0
610 REPEAT
620 WAIT .2
630 Times=Times+.2
640 OUTPUT Addr;”CELL:CALL:STATUS:STATE?”
650 ENTER Addr;Stat$
660 IF Stat$=”””ALERTING””” THEN
670 DISP “Mobile is ringing, answer call”
680 END IF
690 UNTIL ((Stat$=”””CONNECTED”””) OR (Times>Page_tout))
700 !
710 !
720 !
730 ! Check to ensure the page timeout did not expire before continuing
740 !
750 IF Times>Page_tout THEN
760 PRINT “Mobile did not respond to page within “;Page_timeout;”seconds.”
770 STOP
780 END IF
790 !
800 !
810 !
820 ! Display the Dual Band control screen and set up the Downlink Amplitudes
830 !
840 DISP “Prepare for inter-band assignment to DCS”
850 OUTPUT Addr;”DISP DBAND”
860 OUTPUT Addr;”DUAL:AMPL:GTCH -85DBM” ! Ampl of E-GSM BCH + TCH
870 OUTPUT Addr;”DUAL:AMPL:DTCH -80DBM” ! Ampl of DCS TCH
880 OUTPUT Addr;”DUAL:ATT:GBCH ‘30 dB’” ! Ampl of E-GSM BCH when TCH is DCS
890 !
900 !
910 !
920 ! First do an assignment to the DCS band. Setup the DCS band parameters
930 OUTPUT Addr;”DUAL:TCH:DCS “;Dcs_arfcn
940 OUTPUT Addr;”DUAL:TLEV:DCS 5”
950 OUTPUT Addr;”DUAL:TCHC:MODE ‘ASSIGN’”