User`s guide
3
Configuring the HP/Agilent 8922 Multi-Band Test System
Connection Overview
Connection Overview
Connecting the HP/Agilent 8922 to the HP/Agilent 83220 is very similar to
connecting a Standard HP/Agilent 8922 Test System. The main difference being
that an additional cable is used between the HP/Agilent 8922 and the HP/
Agilent 83220. Testing of mobiles in all bands is now carried out from a single
port on the HP/Agilent 83220.
To configure the HP/Agilent 8922 Multi-Band Test System for making
measurements, there are three main stages;
1 Connect the HP/Agilent 8922 to the HP/Agilent 83220. Refer to ‘Connection
Details’ on page 4
and onwards for more information.
2 Carry out a system calibration process. Refer to ‘Calibration Routine’ on page 7
onwards for more information.
3 Zero the power meter. Refer to ‘Zero the Power Meter’ on page 9 for more information.
NOTE: If the HP/Agilent 8922 and the HP/Agilent 83220 are not connected properly an error
message will appear during power-up. Check all connections and switch the HP/
Agilent 8922 off and then on again. If the error message still appears contact your local
sales and service office for more assistance.
For additional information about connections and setting up, refer to the
appropriate sections in the Agilent 8922M⁄S User’s Guide and the Agilent
83220A⁄E User’s Guide