Specifications

Chapter 3 65
Problem Solving
If a test procedure does not run
If a test procedure does not run
NOTE Running a pre-defined test procedure ensures that the software
necessary to run a test procedure is loaded into the HP/Agilent 8922
RAM memory. Try running a pre-defined test procedure, then re-try the
test procedure that would not run.
• Make sure the memory card is correctly inserted into the HP/Agilent
8922.
• Make sure that a Test Procedure file has been loaded into the
HP/Agilent 8922.
In the upper left corner of the TESTS screen, a file name should be
seen in the Procedure field. If the field is blank, then a Test
Procedure file has not been loaded. Refer to “Pre-defined test
procedures” on page 14.
• Make sure that you have selected the Run Test field to start
testing.
• Make sure that if running the procedure DUALBAND, then the test
system is a Multi-Band Test System.
The test procedure DUALBAND only runs on a Multi-Band Test
System. Unpredictable results can occur if it is run on a non
Multi-Band Test System.