Specifications

Chapter 2 53
Using Worksheets
WORKSHEETS FOR DCS1800
NOTE Each time a procedure is selected, the specifications list assumes the
values defined by that procedure.
22 TX power/time template ±18µs dBc or
dBm
−30 dBc or
−20 dBm
n/a n/a
23 TX power/time template
±28µs
1
dBc or
dBm
−48 dBc or
−48 dBm
n/a n/a
24 TX power/time template neg
peak flatness
dB −1.00
25 TX power/time template pos
peak flatness
dB 1.00
26 TX SACCH RX level error dB −3.00 3.00
27 TX RACH burst timing
measurement
T −1.00 1.00
28 TX RACH frequency error Hz −180.00 180.00
29 TX RACH peak power error dB
44
n/a n/a
30 TX RACH phase error (peak) degrees 20.00
31 TX RACH phase error (rms) degrees 5.00
32 TX RACH power/time
template at ±10 µs
dB
−6.00
3
n/a n/a
33 TX RACH power/time
template at ±18 µs
dB −30.00 n/a n/a
34 TX RACH power/time neg
peak flatness
dB −1.00
35 TXRACHpower/time pos peak
flatness
dB 1.00
36 TX worst case frequency error Hz −180.00 180.00
37 TX worst case phase error
(peak)
degrees 20.00
38 TX worst case phase error
(rms)
degrees 5.00
39 TX peak power error for pcl ≥ 9dB
44
n/a n/a
1 HP/Agilent 8922 with Spectrum Analyzer Option 006 only
2 PCL (power Control Level) refers to mobile TX level
3 For power control levels 16, 17 and 18 and above see page 123
4 Dependent on power control level, see page 123
DCS1800 SPECIFICATIONS worksheet for:
Used? Step
no.
Description Units DCS1800
default
lower
limit
DCS1800
default
upper
limit
Lower
limit
Upper
limit