Specifications

Chapter 1 29
Operating the Agilent Technologies 83212D Software
Making your own test procedures
Cross reference of tests to parameters
Most tests are influenced by one or more parameters. Use the following
table to identify which parameters are applicable to each test.
Editing the test specifications
From the Edit Procedure screen (see “Procedure development – edit
procedure” on page 25), do the following:
Step 1. Press and select the field Test Function.
Step 2. From the list of Choices in the revealed box, select Edit Spec and
edit the Test Specifications as described below.
Step 3. When finished editing parameters select to return to the test
screen.
1. Select either Edit Seqn or Edit Parm from the test function field
to continue editing, or
2. If editing is complete, select and press or select
Continue to return to the Edit Proc screen, then press or
select Run to run the modified test procedure.
For more details of the fields, see “TESTS (Edit Specifications)” on
page 170.
Table 1-2 Cross–Reference of Tests to Pre–Defined Test Sequences
Description Test name Parameters used
TEST_01 MS Information 1-12, 14, 16, 20, 31, 47
TEST_02 CP BS Originate 1-12, 14, 16, 20, 31, 47
TEST_03 CP MS Originate 3-12, 14, 16, 20, 31, 47
TEST_04 CP Speech Quality 3-12, 14, 16, 20, 31, 47
TEST_05 TX In-channel Tests 3-11, 14-16, 20, 31-35, 45, 47
TEST_06 TX Peak Power 3-11, 14-16, 20, 31, 36-39, 47, 48
TEST_07 TX ORFS Due to Modulation 3-12, 14-16, 20, 31, 40, 41, 44, 47
TEST_08 TX ORFS Due to Ramping 3-12, 14, 16, 20, 31, 47
TEST_09 RX Reference Sensitivity (TCH/FS) 1-11, 14, 16, 21-28, 31, 47
TEST_10 RX Usable Input Level Range 3-12, 14-16, 21, 22, 26-31, 47
TEST_11 RX Timebase Tuning Range 3-11, 14-16, 18, 20, 31, 47
TEST_12 MS Quick Test 3-12, 16, 20, 22, 23, 31, 32, 47
TEST_13 MS Flow Chart 3-12, 14-16, 20-25, 31, 47
TEST_14 TX RACH test 11, 12, 31
TEST_15 CP End Call —
TEST_16 Dual-Band Handover —
TESTS
TESTS
TESTS L2
L1