Specifications

Chapter 1 27

Operating the Agilent Technologies 83212D Software

Making your own test procedures

Figure 1-12 Edit Sequence Screen on the Agilent 83212D

Editing the test parameters

From the Edit Procedure screen (see “Procedure development – edit

procedure” on page 25), select the following keys:

Step 1. and select the ﬁeld Test Function at the bottom of the

screen.

Step 2. From the list of Choices in the revealed box, select Edit Parm and

edit the Test Parameters as described below.

Step 3. When ﬁnished editing parameters select to return to test

screen.

1. Select either Edit Seqn or Edit Spec from the test function ﬁeld

to continue editing, or

2. If editing is complete, select and press or select

Continue to return to the Edit Proc screen, then press or

select Run to run the modiﬁed test procedure.

NOTE

For a fuller explanation of the ﬁelds, see “TESTS (Edit Parameters)” on

page 172.

TESTS

TESTS L2