Specifications

Chapter 1 26

Operating the Agilent Technologies 83212D Software

Making your own test procedures

Editing the test sequence

From the Edit Procedure screen (see “Procedure development – edit

procedure” on page 25), select the following keys:

Step 1. and select the ﬁeld Test Function at the bottom of the

screen.

Step 2. From the list of Choices in the revealed box, select Edit Seqn and

edit the Test Sequence as described below.

Step 3. When ﬁnished editing sequence select to return to test

screen.

1. Select either Edit Parm or Edit Spec from the test function ﬁeld

to continue editing, or

2. If editing is complete, select and press or select

Continue to return to the Edit Proc screen, then press or

select Run to run the modiﬁed test procedure.

NOTE

For a fuller explanation of the ﬁelds see “TESTS (Edit Sequence)” on

page 168.

To add tests To add tests, select the following keys according to the labelled steps in

Figure 1-12 on page 27.

Step 1. Press or select Insrt Stp to insert a step.

Step 2. Select the test name (example TEST_09) to modify the inserted step.

Step 3. Select a new Test name for the inserted step.

Step 4. Press or select Delet Stp to remove steps from a procedure.

TESTS

TESTS L2