Specifications

Chapter 1 22
Operating the Agilent Technologies 83212D Software
Selecting a test sequence — Test Sequence menu
Cross–reference of tests to pre–defined test sequences
Use the following table to find descriptions of tests used in Pre-Defined
Test Sequences. Only one test at a time can be run.
If you select test 12 (MS Quick Test) from the Individual sub-menu,
the test that is run is exactly the same as if you had selected Quick
Test from the Test Sequence Menu. Similarly, if you select test 13
individually, then this executes the same test as Flowchart from the
Test Sequence Menu. For details on the individual tests, see chapter 4 ,
Tests.
Table 1-1 Cross reference of tests to pre-defined test sequences
Pre–Defined Test
Sequences
Test Name Description Flowchart Quick
Test
Full
Test
TEST_01 MS Information Used
TEST_02 CP BS Originate
TEST_03 CP MS Originate
TEST_04 MS Speech Quality Used
TEST_05 TX In-channel Tests Used
TEST_06 TX Peak Power Error Used
TEST_07
TX ORFS Due to Modulation
1
Used
TEST_08
TX ORFS Due to Ramping
1
Used
TEST_09 RX Reference Sensitivity (TCH/FS) Used
TEST_10 RX Usable Input Level Range Used
TEST_11
RX Timebase Tuning Range
2
Used
TEST_12 MS Quick Test Used
TEST_13 MS Flow Chart Used
TEST_14 TX RACH Test
TEST_15 CP End Call Used
TEST_16 Dual-Band Handover
Used
3
1 HP/Agilent 8922 with option 006 only
2 Not available on HP/Agilent 8922E
3 Only if Dual-Band procedure is used