Specifications

Chapter 8 188

Working with Memory Cards

Replacing the memory card battery

The SRAM memory-card requires a 3 volt 2016 coin cell.

Step 1. With the power on, insert the card into the HP/Agilent 8922. An

inserted memory card takes power from the HP/Agilent 8922,

preventing the card’s contents from being lost.

Step 2. Hold the card in the slot with one hand while pulling the battery out

with the other. Also, be sure to install the battery with the side marked

“+” on the same side marked “+” on the battery holder.

Figure 8-7 Replacing the memory card battery

NOTE

Avoid touching the ﬂat sides of the battery when replacing it. Finger

oils may contaminate battery contacts in the memory-card.

WARNING

Discard unused batteries according to the manufacturer’s

instructions.