Specifications

Chapter 1 8

Operating the Agilent Technologies 83212D Software

Getting started

Loading the Agilent 83212D software from memory card

NOTE

The ﬁrst time you run the program, there is a delay of approximately

two minutes while the new code is read from the memory card.

Subsequent running of the program does not have this delay. When the

program is successfully read on the ﬁrst run, the new software revision

number appears on the screen below the copyright notice for a few

seconds.

Step 1. Insert the Agilent 83212D memory card in the slot on the front panel of

the HP/Agilent 8922.

Figure 1-2 Inserting a memory card

You can insert or remove memory cards with the HP/Agilent 8922

powered on or off. Memory cards must be inserted for test procedures to

run. To remove a memory card, simply pull it out. For more details on

memory cards, see chapter 8 , Working with Memory Cards..

NOTE

Do not remove or change a memory card while running a test.

Step 2. Press the key on the front panel of the HP/Agilent 8922 to

go to the screen, select the ﬁeld named Location and from

the Choices Menu select Card.

Step 3. Select the preceding ﬁeld Procedure and from the Choices Menu

select GSM900, DCS1800 or PCS1900 (see “Pre-deﬁned test procedures”

on page 14 for more details).

Step 4. Set the Autostart ﬁeld toggle to On (see “Using Autostart” on page 10

for more details) and press or select Run Tests to run the tests.

TESTS