Specifications

Chapter 7 175
Screens
TESTS (Edit Configuration)
3. Delet Ins This field deletes the currently selected device.
4. Edit Freq This field is not used by the Agilent 83212D software. (Firmware
versions of 5.00 and above will show Edit Parm in this position)
5. Edit Seqn This field is used to select tests and test sequence.
6. Insrt Ins This field inserts a duplicate of the currently selected device.
7. Inst# This field assigns a number to the instruments being configured.
8. Model This field is used for entering the model number of the device described
in the Calling Name field. This field can be left blank.
9. Options This field is for additional information about the configuration. This
field can be left blank.
To enter options:
Step 1. Select the Options field. (An alpha/numeric list of characters appears
in the lower-right corner of the screen.)
Step 2. Use the knob on the front panel of the HP/Agilent 8922 to select
characters.
Step 3. Select Done when you are finished.
10. Print All This field outputs the contents of the CRT display to a printer.
11. Test Function This field selects the screens used in the tests subsystem. Choices are:
• Edit Seqn is used to select tests and test sequence.
• Edit Freq is not used by the Agilent 83212D software.
• Edit Spec is used to enter test limits.
• Edit Parm is used to enter test parameters.
• Edit Cnfg is used to configure the HP/Agilent 8922 for peripheral
devices such as printers and power supplies.
• Proc Mngr is used to make or delete test procedures.
• IBASIC provides direct access to the IBASIC controller.