Specifications

Chapter 7 170
Screens
TESTS (Edit Specifications)
TESTS (Edit Specifications)
Figure 7-3 TESTS (Edit Specifications) screen
1. Check This field enables measurement limits. Choices are:
• Upper causes the upper limit to be checked.
• Lower causes the lower limit to be checked.
• Both causes both limits to be checked.
• None causes neither limit to be checked.
2. Description This field displays a description (for example, TX average phase error)
of a specification.
3. Edit Freq This field is not used by the Agilent 83212D software. (Firmware
versions of 5.00 and above will show Edit Parm in this position)
4. Edit Seqn This field is used to select tests and the test sequence.
5. Lower and
Upper Limits
These fields allow measurement limits to be set for the selected
specification. When enabled and measurement limits are exceeded, an
“F” (for fail) is displayed next to the measurement result.
6. Print All This field outputs a list of the current specifications to a printer. See
“Printing test results” on page 35 for details.
7. Spec# This field selects the specification to edit.