Specifications

Chapter 6 157
Test Parameters
Parameter descriptions
40 TX ORFS Modulation
NOTE This parameter is not used with the HP/Agilent 8922 unless a spectrum
analyzer is installed.
This parameter allows you to select the first 6 (of 11) frequency offsets
to be used when testing the output-RF-spectrum (ORFS) due to
modulation.
• 000010 = 0.6 MHz
• 000100 = 0.4 MHz
• 001000 = 0.25 MHz
• 010000 = 0.2 MHz
• 100000 = 0.1 MHz
• 111110 = All of the above offset frequencies
The offset frequencies are selected by entering a numeral “1” in the
correct “XXXXXX” position.
NOTE The value 000001 is not used and is reserved for future use.
Default value The default frequency offsets are 111110 (all offsets).
Example Enter 100000 in the value field to test ORFS modulation at 0.1 MHz,
which corresponds with the “1XXXXX” parameter position.
NOTE ORFS due to modulation measurements are performed both below and
above the carrier at each of the selected offset frequencies.