Specifications

Chapter 6 151
Test Parameters
Parameter descriptions
26–28 RX Tests Start, Step, and Stop Channels
These parameters allow you to set up the channels to be used when
performing receiver (RX) tests. The range is 1 to 124.
Default values
Example If you want a receiver test performed on channels 10, 62, and 114, enter
the following:
• 10 as the start value for parameter RX ref sens sweep test
start channel,
• 52 as the step value for parameter RX ref sens sweep test
step channel, and
• 114 as the stop value for parameter RX ref sens sweep test
stop channel.
NOTE When parameter RT TCH [0=static 1=hopping 3 freqs] is set to
Hopping 3 freqs (1), the HP/Agilent 8922 will hop between traffic
channels 1, 63, and 124 (512, 699, and 885 for DCS1800; 512, 661 and
810 for PCS1900). The values entered for RX Tests Start, Step, and
Stop Channels will not be used.
Default start
channel
Default step
channel
Default stop
channel
GSM900 1 62 124
DCS1800 512 187 885
PCS1900 512 149 810