User`s guide

G-3
Appendix G - [:MET] - Measurement Fields Using Meters
Commands
Commands
METer METer
METer commands. NOTE : These are only useful for continuous measurements.
METer:
HEND
METer:HEND?
METer:HEND <numeric value>
Sets/queries the High END value to display on the METer for the measurement.
METer:
DUNits
METer:DUNits?
METer:DUNits <meter display unit>
Sets/queries the measurement METer High END Displayed UNits.
METer:
INTerval
METer:INTerval?
METer:INTerval <numeric value>
Sets/queries the number of INTervals to display on the METer between the low end and
high end for the measurement.
METer:
LEND
METer:LEND?
METer:LEND <numeric value>
Sets/queries the Low END value to display on the METer for the measurement.
METer:
LEND:
DUNits
METer:LEND:DUNits?
METer:LEND:DUNits <meter display unit>
Sets/Queries the measurement METer Low END Displayed UNits.
METer:
STATe
METer:STATe?
METer:STATe ON | OFF | 1 | 0
Sets/queries the METer STATe.
Note: ON = 1 and OFF = 0.