User`s guide

D-4
Appendix D - [:MM] - Measurement Fields
Commands
LLIMit:
DUNits
LLIMit:DUNits?
LLIMit:DUNits <measurement unit>
Sets/Queries the measurement Low LIMit Displayed UNits.
LLIMit:
EXCeeded
LLIMit:EXCeeded?
Queries whether the Low LIMit for the measurement was EXCeeded.
LLIMit:
RESet
LLIMit:RESet
RESet the Low LIMit exceeded state so that new limit data can be acquired.
LLIMit:
STATe
LLIMit:STATe?
LLIMit:STATe ON | OFF | 1 | 0
Sets/queries the Low LIMit STATe. Note: ON = 1 and OFF = 0.
LLIMit
[:VALue]
[:VALue]?
[:VALue] <numeric value>
Sets/queries the measurement Low LIMit VALue.
REFerence REFerence
Measurement REFerence information.
REFerence:
DUNits
REFerence:DUNits?
REFerence:DUNits <measurement unit>
Sets/queries the REFerence Displayed UNits on the front panel for the given
measurement.
REFerence:
STATe
REFerence:STATe
REFerence:STATe ON | OFF | 1 | 0
Sets/queries the REFerence STATe. Note: ON = 1 and OFF = 0.
REFerence
[:VALue]
REFerence[:VALue]?
REFerence[:VALue][<numeric value>]
Sets/queries the measurement REFerence VALue. If no <numeric value> is specified, then
the REFerence VALue will be set to the current measurement result.