User`s guide

40-7
Trigger Subsystem
HTCH:ARFCn[:SPECific]
HTCH:ARFCn[:SPECific]
Description Sets/queries the SPECific ARFCn to use for a Hopping TCH measurement when
TRIGger:TCH is set to ‘SPECific’.
Syntax TRIGger:HTCH:ARFCn[:SPECific]?
TRIGger:HTCH:ARFCn[:SPECific] <integer>
Options Not Applicable.
HTCH:ARFCn:AUTO
Description Queries the ARFCn that is being used for a Hopping TCH measurement when
TRIGger:TCH is set to ’AUTO’. This value is the lowest ARFCN in the currently used MA
table (MA1 or MA2).
Syntax TRIGger:HTCH:ARFCn:AUTO?
Options Not Applicable.
[:IMMediate]
Description IMMediately TRIGgers the currently active measurement.
Syntax TRIGger[:IMMediate]
Options Not Applicable.
NOTE ABORt, [:IMMediate], and MODE are remote-only commands and apply to the following
types of measurements: AF Analyzer, CW Meas, OSCilloscope, and SANalyzer.