User`s guide

40-4
Trigger Subsystem
ABORt
ABORt
Description ABORts TRIGgering of a measurement that has been triggered using TRIGger:IMMediate.
Syntax TRIGger:ABORt
Options Not Applicable.
NOTE ABORt, [:IMMediate], and MODE are remote-only commands and apply to the following
types of measurements: AF Analyzer, CW Meas, OSCilloscope, and SANalyzer.
ASTate
Description Selects/queries the Arm STate of the currently selected measurement. This command is
used for all appropriate measurements listed in the MEASure subsystem.
Syntax TRIGger:ASTate?
TRIGger:ASTate <string>
Options ’ARM’ | ’DISARM’
NOTE ASTate, SOURce, MODE[:DSPanalyzer] and UMEMory apply to the following types of
measurements: DSPanalyzer - Phase, Amplitude, Data Bits PULSe - Pulse On/Off Ratio
ORFSpectrum - Output RF Spectrum DELay and HTCH apply to Digital Demod and Bit
Error Test as well as the above measurements.
BETest
Description Selects/queries the TRIGger for Bit Error Test measurements for local operation.
Syntax TRIGger:BETest?
TRIGger:BETest <string>
Options ’SINGLE’ | ’CONT’
Where;
• SINGLE means each Bit Error Test measurement will just be made once (based on each
measurement’s definition of number of bits to make the measurement over).
• CONT means make each Bit Error Test measurement continuously, repeatedly,
copying Intermediate results into Complete results as one or more of the termination
conditions are met.