User`s guide

33-4
RF Generator Subsystem
FREQuency
FREQuency
Description Sets/queries the non-hop FREQuency of the RF Generator.
Default GPIB unit is HZ.
Default display unit is MHZ.
Syntax RFGenerator:FREQuency?
RFGenerator:FREQuency <real> | [:FNUM]
Options Refer to Appendix B.
MODulation:DCAM
Description Selects/queries the state of DC AM MODulation.
NOTE This command is not available in the Agilent 8922S.
Syntax RFGenerator:MODulation:DCAM?
RFGenerator:MODualtion:DCAM <string>
Options ’EXTERNAL’ | ’OFF’ | ’TCH LOWER’ | ’BCCHLOWER’ | ’BOTHLOWER’
Where;
• EXTERNAL means DC AM comes from an external AM input.
• OFF means no DC AM.
• TCH LOWER means the BCCH will be at the RF Level of the RF Analyzer Amplitude
setting and the TCH RF Level will be lower by the dB determined by setting
RFANalyzer:INPut.
• BCCHLOWER means the TCH will be at the RF Level of the RF Analyzer Amplitude
setting and the TCH RF Level will be lower by the dB determined by setting
RFANalyzer:INPut.
• BOTHLOWER means both the TCH and the BCCH will be lower by the dB
determined by setting RFANalyzer:INPut.