User`s guide

31-4
Pulse On/Off Ratio Commands (Measure Subsystem)
MARKer:LEVel:RISE
MARKer:LEVel:RISE
Description Queries the RISE trace MARKer LEVel which is relative amplitude data. This value is a
function of the marker position set or queried by PULS:MARK:POS:RISE.
Default unit is dB relative to the average power over the useful bits in the measured burst.
GPIB units are dB.
Display units are dB.
Syntax MEASure:PULSe:MARKer:LEVel:RISE?
MEASure:PULSe:MARKer:LEVel:RISE[:MM] | [:AVG]
Options Refer to Appendices D and F.
MARKer:TIME:FALL
Description Queries the FALL trace TIME which is the marker’s position relative to bit zero in the
measured burst. This value is a function of the marker position set or queried by
PULS:MARK:POS:FALL.
GPIB units are seconds (S), bit periods (T);
default unit is seconds (S).
Display units are US (micro-second), T (bit periods);
default unit is US (micro-second).
Syntax MEASure:PULSe:MARKer:TIME:FALL?
MEASure:PULSe:MARKer:TIME:FALL[:MM] | [:AVG]
Options Refer to Appendices D and F.