User`s guide

26-5
OSCilloscope Subsystem
SCALe:VERTical:OFFSet
SCALe:VERTical:OFFSet
Description Sets/queries the number of divisions that the displayed signal is VERTically OFFSet above
the Oscilloscope’s fixed center line.
Syntax OSCilloscope:SCALe:VERTical:OFFSet?
OSCilloscope:SCALe:VERTical:OFFSet <real> | [:FNUM]
Options Refer to Appendix B.
SCALe:VERTical:VOLTs
Description Selects/queries the VERTical amplitude per division for AF Analyzer input selections
(AFAN:INP) that have units of VOLTs.
Syntax OSCilloscope:SCALe:VERTical:VOLTs?
OSCilloscope:SCALe:VERTical:VOLTs <string>
Options ’20 V’ | ’10 V’ | ’5 V’ | ’2 V’ | ’1 V’ |
500 mV’ | ’200 mV’ | ’100 mV’ | ’50 mV’ |
‘20 mV’ | ’10 mV’ | ’5 mV’ | ’2 mV’ |
’1 mV’ | ’500 uV’ | ’200 uV’ | ’100 uV’ |
’50 uV’ | ’20 uV’
TRIGger:LEVel
Description Sets/queries the TRIGger LEVel. This only applies when TRIGger:SOURce is ’Scope
Lvl’. The TRIGger LEVel is indicated by small pointers that appear on each side of the
graticule. GPIB units is DIV.
Example: ”OSC:TRIG:LEV 2 DIV” set the oscilloscope trigger to 2 divisions above the
horizontal axis.
Syntax OSCilloscope:TRIGger:LEVel?
OSCilloscope:TRIGger:LEVel <real> | [:INUM]
Options Refer to Appendix A.