User`s guide

21-8

IEEE 488.2 Common Commands

*RCL (Recall)

Description The *RCL command restores the state of the instrument from the

speciﬁed internal save/recall register. An instrument setup must have

been stored previously in the speciﬁed register. Registers 0 through 99

are general purpose and can be used with the *SAV command.

Command Syntax *RCL <rcl_register>

Where <rcl_register> = 0 through 99 though the total number of

registers used may be limited by the amount of memory available.

Example

OUTPUT 714;”*RCL 75”

An instrument state stored using [REGister:]SAVE may be recalled

using *RCL or [REGister:]RECall. If the [REGister:]SAVE uses an

alphanumeric string as the register name, the *RCL command will not

work. *RCL only works with registers named using an integer from 0

through 99.

IMPORTANT The following fields do not participate in Save/Recall, and will be set according to the

recalled state of the operating mode (Active Cell | Test Mode | CW Generator).

• Cell Conﬁg - Settable| | Activated

• Dig Demod Arm State - Arm | Disarm

• DSP Meas - Trig Source

• DSP Meas - Trig Delay

• Demod Arm State - Arm | Disarm

• Meas Arm State - Arm | Disarm

• Meas Sync - Single | Cont

• Bit Error Test - Run | Stop

• Bit Error Test MS Loopback Loop Delay mode - Manual | Auto

• Hop Control RF Generator - Arm | Disarm

• Hop Control RF Analyzer - Arm | Disarm

• Hop Control RF Generator - Non-Hop | Hop

• Hop Control RF Analyzer - Non-Hop | Hop

• None of the CONFigure commands except :RADio,

:ROSCillator:OFFSet, ROSCillator:TUNing, and :PRINt:TITLe

participate in Save/Recall, and will instead remain at their last

setting.