User`s guide

20-6

Hop Control Subsystem

RFANalyzer or RFGenerator:CTENd

Description This Clear To ENd command replaces the RF ANalyzer hop frequency entry at

HOPC:ADDRess, and all hop frequency entries after it, with 0 MHz.

For example;, the hop frequency entry at HOPC:ADDRess, HOPC:ADDRess + 1, ... up to

entry 2047 are replaced with 0 MHz

Syntax HOPControl:RFANalyzer:CTENd

HOPControl:RFGenerator:CTENd

Options Not applicable.

RFANalyzer or RFGenerator:DELete

Description This DELetes the RF ANalyzer hop frequency entry at HOPC:ADDRess. All other RF

ANalyzer hop frequency entries move down by one address. Entry 2047 in the hop table is

replaced with 0 MHz.

Syntax HOPControl:RFANalyzer:DELete

HOPControl:RFGenerator:DELete

Options Not applicable.

RFANalyzer or RFGenerator:FREQuency

Description Set/queries the RF ANalyzer or RF Generator hop FREQuency entry at HOPC:ADDRess.

Default GPIB unit is HZ.

Default display unit is MHZ.

Syntax HOPControl:RFANalyzer:FREQuency?

HOPControl:RFGenerator:FREQuency?

HOPControl:RFANalyzer:FREQuency <real> | [:FNUM]

HOPControl:RFGenerator:FREQuency <real> | [:FNUM]

Options Refer to Appendix B.