User`s guide

20-4
Hop Control Subsystem
ADDRess
ADDRess
Description Sets/queries the ADDRess for entering hop frequencies into the hop tables and for entering
the next frequency for HOPC:ADDR:SOUR:INT mode.
Syntax HOPControl:ADDRess?
HOPControl:ADDRess <integer>? | [:INUM]
Options Refer to Appendix A.
ADDRess:NEXT
Description Sets/queries the NEXT HOP ADDRess to hop to. This is used when HOPC:ADDR:SOUR
is ’INT’ to make looped internal sequences.
Syntax HOPControl:ADDRess:NEXT?
HOPControl:ADDRess:NEXT <integer> | [:INUM]
Options Refer to Appendix A.
ADDRess:RESet
Description RESets the internal sequence hop address register to zero.
Syntax HOPControl:ADDRess:RESet
Options Not applicable.
ADDRess:SOURce
Description Selects/queries the HOP Control ADDRess SOURce.
Syntax HOPControl:ADDRess:SOURce?
HOPControl:ADDRess:SOURce <string>
Options ‘SEQ’ | ‘EXT’
Where;
• SEQ hopping mode causes the hop control address to come from a hop sequence
address register. Hop addresses are automatically sequenced based on next settings.
• EXT hopping mode causes the hop control address to come from external lines.