User`s guide

18-4
Fast Bit Error Test (Measure Subsystem)
BERRor:IRATio
BERRor:IRATio
Description Queries the Bit ERRor Intermediate RATio.
NOTE This can only be queried when in the state TRIGger:BETest:MODE ‘RUN’.
Syntax MEASure:FBETest:BERRor:IRATio?
MEASure:FBETest:BERRor:IRATio[:MM]
Options Refer to Appendix D.
BERRor:RATio
Description Queries the Bit ERRor RATio (completed).
Syntax MEASure:FBETest:BERRor:RATio?
MEASure:FBETest:BERRor:RATio[:MM]
Options Refer to Appendix D.
BESelect
Description Selects/queries the Bit ERRor SELected Bit Error Test measurement to display (BE Ratio,
BE Count) for the given measurement cycle.
Syntax MEASure:FBETest:BESelect?
MEASure:FBETest:BESelect <string>
Options ‘BE COUNT’ | ‘BE RATIO’
SSTatus
Description Queries the Bit Error Test SYNC STatus. Will return ’NO ERROR’ or ’BAD SYNC’. This
field will only be updated when the demod arm state goes from ”DISARM” to ”ARM.” This
is the same as DDEMod:SYNC:SSTatus.
Syntax MEASure:FBETest:SSTatus?
Options Not Applicable