User`s guide

15-4
DSP Analyzer Commands (Measure Subsystem)
[:AMPLitude]:AMPLitude
[:AMPLitude]:AMPLitude
Description Sets the AMPLitude measurement attributes. Queries the AMPLitude measurement result
based on the DSP:AMPL:TIME<n> setting.
Syntax MEASure:DSPanalyzer[:AMPLitude]:AMPLitude<n>?
MEASure:DSPanalyzer[:AMPLitude]:AMPLitude<n>[:MM] | [:AVG]
Options Refer to Appendices D and F.
Where n= 1 through 12
[:AMPLitude]:MARKer:LEVEL:FALL
Description Sets/queries the AMPLitude MARKer FALL trace attributes.
Queries the AMPLitude MARKer FALL trace level which is relative amplitude data. This
value is a function of the fall trace marker position set/queried by
DSP:AMPL:MARK:POS:FALL. This is only valid when on IMPORTANT: The user
MUST be on the Amplitude Fall screen to query this result (DISP:DSP:VIEW ’AMPL
FALL’).
GPIB unit is dB.
Display unit is dB.
Syntax MEASure:DSPanalyzer[:AMPLitude]:MARKer:LEVel:FALL?
MEASure:DSPanalyzer[:AMPLitude]:MARKer:LEVel:FALL[:MM] | [:AVG]
Options Refer to Appendices D and F.