User`s guide

14-4
DSP Analyzer Subsystem
AMPLitude:TIME
AMPLitude:TIME
Description Sets/queries the TIME to make amplitude measurements.
GPIB units are seconds (S), bit periods (T).
Default GPIB unit is seconds (S).
Default display unit is micro-seconds (US).
Syntax DSPanalyzer:AMPLitude:TIME<n>?
DSPanalyzer:AMPLitude:TIME<n> <real>
Options Refer Appendix B.
n=1 through 12
DBITs:TPOLarity
Description Toggles the POLarity of the Data BITs for the current measurement.
Syntax DSPanalyzer:DBITs:TPOLarity
Options Not Applicable.
PHASe:MARKer:POSition
Description Sets/queries the PHASe MARKer POSition setting. The value is given in units of divisions
from the left side of the trace (0 to 14.7 divisions).
Syntax DSPanalyzer:PHASe:MARKer:POSition?
DSPanalyzer:PHASe:MARKer:POSition <real> | [:FNUM]
Options Refer appendix B.
PHASe:MIDamble
Description Selects/queries the MIDamble to use for DSP analyzer phase displays as the actual
measured midamble or the midamble that the user expects to use.
Syntax DSPanalyzer:PHASe:MIDamble?
DSPanalyzer:PHASe:MIDamble <string>
Options ‘MEASURED’ | ‘EXPECTED’