User`s guide

9-16
Cell Control Subsystem
CALL:STATus:RR[:STATe]
CALL:STATus:RR[:STATe]
Description Queries the Radio Source STATe.
Syntax CELL:CALL:STATus:RR[:STATe]?
Options Returns state of signaling as;
’BCCH’ | ’DCCH’ | ’TCH1’ | ’TCH2’ | ’NONE’
Where;
• BCCH means idle on a Broadcast Control CHannel.
• DCCH means on a Dedicated Control CHannel.
• TCH1 means on a Traffic CHannel as defined by TCH1 settings.
• TCH2 means on a Traffic CHannel as defined by TCH2 settings.
• NONE means that the signaling state is totally undefined.
CALL:STATus:STATe
Description Queries the CALL Status STATe.
Syntax CELL:CALL:STATus:STATe?
Options Returns state of the CALL as;
’SETUP REQUEST’ | ’PROCEEDING’ | ’ALERTING’ |
’SETUP CONFIRM’ | ’CONNECTED’ | ’INACTIVE’
CALL:STATus:TCH:ARFCn
Description Queries the current Traffic CHannel ARFCn. This applies if TCH:MODE is ‘SINGLE’.
Syntax CELL:CALL:STATus:TCH:ARFCn?
Options Not Applicable.