User`s guide

9-11
Cell Control Subsystem
CALL:CONNect
CALL:CONNect
Description Selects/queries the connect (mode).
Syntax CELL:CALL:CONNect?
CELL:CALL:CONNect <string>
Options ‘AUTO’ | ‘MANUAL’
Where;
• AUTO means that we will automatically attempt to connect to an MS-initiated call.
• MANUAL means that you must use CELL:CALL:RECeive to receive an MS-initiated
call.
CALL:COUNt:BSYNc
Description Count of Bad syncs detected during this call or since COUNt:RESet.
NOTE It is normal to detect Bad SYNcs during call setup.
Syntax CELL:CALL:COUNt:BSYNc?
Options Not Applicable.
CALL:COUNt:DERRor | FERRor
Description COUNt of Decoding ERRors detected during this call or since COUNt:RESet.
NOTE It is normal to detect Decode ERRors during call setup.
Syntax CELL:CALL:COUNt:DERRor | FERRor?
Options Not Applicable.
CALL:COUNt:PAGE
Description COUNt of PAGEs made during this call or since COUNt:RESet.
Syntax CELL:CALL:COUNt:PAGE?
Options Not Applicable.