User`s guide

7-9
Bit Error Test Commands (Measure Subsystem)
FLTYpe
FLTYpe
Description Selects/queries the Frame Loss Selected Bit Error Test measurement to display (Count or
Ratio) for the given Frame Loss Select (Count or Ration) for the given measurement
number.
Syntax MEASure:BETest:FLTYpe<n>?
MEASure:BETest:FLTYpe<n> <string>
Options ‘FE’ | ‘CRC’
where <n> = 1..4.
IBTested
Description Queries the number of Bits Tested for the Intermediate Bit Error Test measurements.
NOTE This can only be queried when in the state: TRIGger:BETest:MODE ‘RUN’
Syntax MEASure:BETest:IBTested<n>?
Options where <n> = 1..4.
SSTatus
Description Queries the Bit Error Test SYNC STatus. Will return ’NO ERROR’ or ’BAD SYNC’. This
field will only be updated when the demod arm state goes from ”DISARM” to ”ARM.” This
is the same as DDEMod:SYNC:SSTatus.
Syntax MEASure:BETest:SSTatus?
Options Not Applicable