User`s guide

7-4
Bit Error Test Commands (Measure Subsystem)
BESelect
BESelect
Description Selects/queries the Bit Error SELected Bit Error Test measurement to display (BE Ratio,
BE Count) for the given measurement number n,
Syntax MEASure:BETest:BESelect<n>?
MEASure:BETest:BESelect<n> <string>
Options ’BE COUNT’ | ’BE RATIO’
where <n> = 1..4.
BERRor:COUNt
Description Sets the Bit ERRor COUNt MEASurement attributes. Queries the Bit ERRor COUNt
(completed),
Syntax MEASure:BETest:BERRor:COUNt<n>?
MEASure:BETest:BERRor:COUNt<n>[:MM_MOD] | [:AVG]
Options where <n> = 1..4.
Refer to Appendices E and F.
BERRor:ICOunt
Description Sets the Bit ERRor Intermediate COunt MEASurement attributes. Queries the Bit ERRor
COunt (completed).
NOTE: This can only be queried when in the state
TRIGger:BETest:MODE ‘RUN’
Syntax MEASure:BETest:BERRor:ICOUNt<n>?
MEASure:BETest:BERRor:ICOUNt<n>[:MM-MOD] | [:AVG]
Options where <n> = 1..4.
Refer to Appendices E and F.