User`s guide

Chapter 6 6-5
Error Reporting
Status Reporting
Table 6-3 Event Status Register B: Status Bit Definitions
Bit Name Definition
0 Single sweep, number of
groups, or calibration step
complete
A single sweep, group, or calibration step has been completed
since the last read of the register.
1 Service routine waiting or
done
An internal service routine has completed operation, or is
waiting for an operator response.
2 Data entry complete A terminator key has been pressed or a value entered over GPIB
since the last read of the register.
3 Limit failed, Channel 2 Limit test failed on Channel 2.
4 Limit failed, Channel 1 Limit test failed on Channel 1.
5 Search failed, Channel 2 A marker search was executed on Channel 2, but the target
value was not found.
6 Search failed, Channel 1 A marker search was executed on Channel 1, but the target
value was not found.
7 Copy Complete A copy has been completed since the last read of the register.
8 Limit failed, Channel 4 Limit test failed on Channel 4.
9 Limit failed, Channel 3. Limit test failed on Channel 3.
10 Search failed, Channel 4. A marker search was executed on Channel 4, but the target
value was not found.
11 Search failed, Channel 3. A marker search was executed on Channel 3, but the target
value was not found.
12 NDB bandwidth failed,
Channel 1.
The NDB (number of dB below peak) Bandwidth test failed on
Channel 1.
13 NDB bandwidth failed,
Channel 2.
The NDB (number of dB below peak) Bandwidth test failed on
Channel 2.
14 NDB bandwidth failed,
Channel 3.
The NDB (number of dB below peak) Bandwidth test failed on
Channel 3.
15 NDB bandwidth failed,
Channel 4.
The NDB (number of dB below peak) Bandwidth test failed on
Channel 4.
16 Ripple failed, Channel 1. The Ripple test failed on Channel 1.
17 Ripple failed, Channel 2. The Ripple test failed on Channel 2.
18 Ripple failed, Channel 3. The Ripple test failed on Channel 3.
19 Ripple failed, Channel 4. The Ripple test failed on Channel 4.
20
Multi Sweep Done
Multiple sweep calibration is complete.