User`s guide

1-246 Chapter 1

Alphabetical Command Reference

STAN

Syntax

STAN<A|B|C|D|E|F|G>;

Description

Standards A through G are associated with softkeys 1 through 7, respectively.

Front Panel Equivalents

Command Description Range Query Response

STANA These 7 commands (OPC-compatible) select a

standard from a class during a calibration

sequence. If a class is requested, as in CLASS11A

(S11 1-port cal) the analyzer will do one of two

things:

• If there is only one standard in the class, it will

measure that standard automatically.

• If there are several standards in the class, then

one of these commands must be used to select

one of these standards, causing it to be

measured.

N/A N/A

STANB N/A N/A

STANC N/A N/A

STAND N/A N/A

STANE N/A N/A

STANF N/A N/A

STANG N/A N/A

Command Hardkey Softkey

STANA standard listed under softkey 1

STANB standard listed under softkey 2

STANC standard listed under softkey 3

STAND standard listed under softkey 4

STANE standard listed under softkey 5

STANF standard listed under softkey 6

STANG standard listed under softkey 7

Cal