Specifications

5-55
Hardkey/Softkey Reference
Analyzer Functions
enters absolute power values in the swept list table. The
power values are restricted to the current power range
setting.
If port power is uncoupled, power applies to the currently
selected port, otherwise it applies to both ports. (The list
table only displays one port's power values at time due to
limited display area.) To set the alternate port's power
level, you must exit the edit list menus, select a
measurement that activates the alternate port, and then
re-enter the edit list menus.
This key is disabled if is set to .
sets the frequency or power span of a subsweep about a
specified center frequency.
sets the start frequency of a subsweep.
sets the stop frequency of a subsweep.
leads to the select quadrant menu, which provides the
capability of drawing quarter-page plots.
provides access to the select disk menu.
The active entry area displays the letters of the alphabet,
digits 0 through 9, and mathematical symbols. To define a
title, rotate the knob until the arrow ↑ points at the first
letter, then press . Repeat this until
the complete title is defined, for a maximum of 50
characters. As each character is selected, it is appended to
the title at the top of the graticule.
prompts the analyzer to run a series of tests to determine
a problem.
accesses a series of sequencing menus. These allow you to
create, modify, and store up to 6 sequences which can be
run automatically.
activates editing mode for the segment titled "SEQ1"
(default title).
activates editing mode for the segment titled "SEQ2"
(default title).
activates editing mode for the segment titled "SEQ3"
(default title).
activates editing mode for the segment titled "SEQ4"
(default title).
activates editing mode for the segment titled "SEQ5"
(default title).
SEGMENT POWER
LIST POWER
OFF
SEGMENT: SPAN
SEGMENT: START
SEGMENT: STOP
SEL QUAD
SELECT DISK
SELECT LETTER
SELECT LETTER
SELF DIAGNOSE
Seq
SEQUENCE 1 SEQ1
SEQUENCE 2 SEQ2
SEQUENCE 3 SEQ3
SEQUENCE 4 SEQ4
SEQUENCE 5 SEQ5