Specifications

5-54
Hardkey/Softkey Reference
Analyzer Functions
is the normal scale selection for plotting on blank paper. It
includes space for all display annotations such as marker
values, stimulus values, etc. The entire display fits within
the user-defined boundaries of P1 and P2 on the plotter,
while maintaining the exact same aspect ratio as the
display.
expands or reduces the horizontal and vertical scale so
that the lower left and upper right graticule corners
exactly correspond to the user-defined P1 and P2 scaling
points on the plotter. This is convenient for plotting on
preprinted rectangular or polar forms (for example, on a
Smith Chart).
makes scale per division the active function. A menu is
displayed that is used to modify the vertical axis scale and
the reference line value and position. In addition this
menu provides electrical delay offset capabilities for
adding or subtracting linear phase to maintain phase
linearity.
searches the trace for the next occurrence of the target
value to the left.
searches the trace for the next occurrence of the target
value to the right.
moves the active marker to the maximum point on the
trace.
moves the active marker to the minimum point on the
trace.
turns off the marker search function.
searches for the user-specified target point on the trace.
specifies which limit segment in the table is to be modified.
A maximum of three sets of segment values are displayed
at one time, and the list can be scrolled up or down to show
other segment entries. Use the entry block controls to
move the pointer > to the required segment number. The
indicated segment can then be edited or deleted. If the
table of limits is designated “EMPTY,” new segments can
be added using the or softkey.
sets the center frequency of a subsweep in a list frequency
sweep.
enters the IF bandwidth for the active segment in a swept
list table. This key is disabled if is
set to OFF.
SCALE PLOT [FULL]
SCALE PLOT [GRAT]
Scale Ref
SEARCH LEFT
SEARCH RIGHT
SEARCH: MAX
SEARCH: MIN
SEARCH: OFF
SEARCH: TARGET
SEGMENT
ADD
EDIT
SEGMENT: CENTER
SEGMENT IF BW
LIST IF BW on OFF