Technical data

1-3

Installing the 86100C

WARNING If this product is not used as specified, the protection provided by the

equipment could be impaired. This product must be used in a normal

condition (in which all means for protection are intact) only.

WARNING No operator serviceable parts inside. Refer servicing to qualified

service personnel. To prevent electrical shock do not remove covers.

WARNING This is a Safety Class 1 Product (provided with a protective earthing

ground incorporated in the power cord). The mains plug shall only be

inserted in a socket outlet provided with a protective earth contact.

Any interruption of the protective conductor inside or outside of the

product is likely to make the product dangerous. Intentional

interruption is prohibited.

CAUTION VENTILATION REQUIREMENTS: When installing the product in a cabinet, the

convection into and out of the product must not be restricted. The ambient

temperature (outside the cabinet) must be less than the maximum operating

temperature of the product by 4° C for every 100 watts dissipated in the

cabinet. If the total power dissipated in the cabinet is greater than 800 watts,

then forced convection must be used.

CAUTION This product is designed for use in INSTALLATION CATEGORY II and

POLLUTION DEGREE 2 per IEC 1010 and 664 respectively.

Installation Category: Installation Categories (overvoltage categories) are

determined by the transient overvoltage levels that may be expected. CAT I:

Mains isolated. CAT II: Line voltage in appliance and to wall outlet. CAT III:

Line voltage behind wall outlet to next level of distribution.

Instrument Markings The instruction manual symbol. The product is marked with this warn-

ing symbol when it is necessary for the user to refer to the instructions

in the manual.

The laser radiation symbol. This warning symbol is marked on products

which have a laser output.

The ON, ON, STANDBY, OFF, OFF and AC symbols.

The ON, OFF, and STANDBY mark the position of the

instrument power line switch. The AC symbol is used to indicate the required

nature of the line module input power.

The CE mark is a registered trademark of the European Community.

The CSA mark is a registered trademark of the Canadian Standards

Association.

ON, ❘, OFF, ❍