Technical data

1-31
Installing the 86100C
To use the removable hard disk option
b On the Setup menu, click Acquisition to open the Acquisition dialog box.
c On the Waveform tab, click Manual and enter a value of 4096.
d Close the Acquisition dialog box.
e On Option 001 instruments, click the Pattern Lock button shown in
Figure 1-23. When the Pattern Autodetect Fail dialog box is displayed,
click Cancel to close the dialog box.
Figure 1-23. Pattern Lock Button
4 Reset the remote interface (GPIB) address using the following steps:
a On the Utilities menu, click Remote Interface.
b Enter a GPIB address value of 7 and close the dialog box.
5 Reset the Quick Measure utility to its default measurements using the following
steps:
a On the Measure menu, click Quick Measure Config.
b Select the Apply Default Setup to Quick Measure check box, which is
located at the bottom of the dialog box.
c Close the dialog box.
Pattern Lock