Technical data

1-11

Installing the 86100C

Step 6. Connect the power

CAUTION Always use the three-prong AC power cord supplied with this instrument.

Failure to ensure adequate earth grounding by not using this cord may cause

product damage.

CAUTION Do not connect ac power until you have verified the line voltage is correct as

described in Table 1-2 on page 1-7. Damage to the equipment could result.

• Connect the line cord as shown in the figure below.

Figure 1-5. Line Cord Connector on 86100C Rear Panel

The 86100C automatically adjusts for line input voltages of 115 VAC and

230 VAC. There is no voltage selection switch. The line cord provided is

matched by Agilent to the country in which the order originates. Refer to

Table 1-3, “Available Line Cords,” on page 1-13 for a list of other available line

power cords.