User`s guide

2-5

Installing

Step 3. Connect the line-power cable

Verify that the line power meets the requirements shown in the following table.

Connect the line-power cord to the instrument’s rear-panel connector.

Connect the other end of the line-power cord to the power receptacle.

The lightwave switch is equipped with a three-wire power cable, in accor-

dance with international safety standards. When connected to an appropriate

power line outlet, this cable grounds the instrument cabinet.

Various power cables are available to connect the lightwave switch to the

types of ac power outlets unique to specific geographic areas. The cable

appropriate for the area to which the lightwave switch is originally shipped is

included with the unit. You can order additional ac power cables for use in dif-

ferent areas. “Power Cords” on page 2-6 lists the available ac power cables,

illustrates the plug configurations, and identifies the geographic area in which

each cable is appropriate.

Table 2-1. Agilent 86060C-Series Power Requirements

Characteristic Requirement

Input Voltage within range 90 to 254 Vac

Frequency within range 47 to 63 Hz

Power 80 VA (maximum)