User`s guide

SELECT
FREQ
allows you to enter the frequency value for a limit-line segment or for an
amplitude-correction point. Enter the frequency value for the frequency by
using the data keys. Change the frequency value by using the step keys or the
knob. Press [jSP) to correct errors.
A frequency coordinate must always be specified for either limit lines or
amplitude-correction factors.
Note
Limit-line data is sorted in frequency order in the limit-line table. The sorting
occurs after you have entered the frequency and at least one amplitude value.
For amplitude-correction factors, only two entries with the same frequency are
valid. Only the first and last points of a series with the same frequency values
are used; the middle points are ignored.
Amplitude-correction data is sorted in the table by frequency. The sorting
occurs immediately after you have entered the frequency value via the
front-panel.
SELECT
LWR AMPL
SELECT
MID AMPL
SELECT
POINT
SELECT
PREFIX
SELECT
SEGMENT
Front-Panel Key Access: (CAL) or (jjj
allows you to enter the amplitude value for the lower limit-line segment.
Enter the amplitude value for the selected frequency or time by using the
knob or data keys. Press c-1 to correct errors.
Front-Panel Key Access: CDISPLAY]
allows you to enter the middle amplitude value. The middle amplitude value
and the delta amplitude value create upper and lower limit-line segments.
Enter the amplitude value for the selected frequency or time by using the
knob or data keys. Press (ml to correct errors.
Front-Panel Key Access: c-1
allows you to create or edit an amplitude-correction factor data point. Enter
the point number to be created or edited by using the data keys, then press
(ENTER]. Press [BKSP) to correct errors.
Front-Panel Key Access: (CAL)
allows you to select an already existing prefix of a cataloged file and changes
the current prefix to this selected prefix. This provides a convenient method
for saving and recalling data to and from the memory card and for cataloging
by the prefix. Use either the knob or step keys to select the file.
Front-Panel Key Access: [RECALL] or ISAVE_)
allows you to create or edit a limit-line segment. Limit lines are created by
entering frequency (or time) and amplitude values into a limit-line table.
The frequency (or time) and amplitude values specify a coordinate point
from which a limit-line segment is drawn. The coordinate point is the lowest
frequency or time point of the line segment. Limit lines are constructed from
left to right. To select a segment, press SELECT SEGMENT, enter the segment
number you wish to specify, then press a units key.
Up to 20 segments can be specified per limit-line table.
Front-Panel Key Access: c-1
Key Descriptions 7-77