Specifications
b. Using hole pattern “B,” attach one adapter bracket to the
rear of each outer slide mount, using two
M5x0.8~12
pan-head
screws and nuts per bracket.
c. Bolt an outer slide mount to each side of the system rack
cabinet using
M5x0.8~12
pan-head screws. Use the bar
nuts provided in the kit if the rack mounting strips have
through-holes.
Note
If any binding is encountered in the slides after mounting, it will be
necessary to slightly move the adapter brackets. While supporting
the instrument, loosen one of the adapter brackets. Adjust the slides
slightly until they operate freely. Retighten the adapter brackets.
20. Connect the ac line power cords.
21. If the HP 8568B will be remotely controlled, refer to “‘Ib Set the
HP-IB Address” in this chapter.
22. When you turn your instrument on for the first time, you should
perform the verification tests in Chapter 5. Refer to the HP
8568B
Operation and Programming Manual for instructions on using
the instrument.
Note
Cables W37 and W38 are removed for connection of the IF and VIDEO
ports to the HP 85650A Quasi-Peak adapter. If the instrument is used
without the HP 85650A Quasi-Peak adapter, W37 and W38 must be
connected for the instrument to operate.
Installation 2-19