Specifications

To Install Option
010 Instruments
Option 010 mounts the HP 8568B on slides in a rack of 482.6 mm
(19 in) spacing. (Option 010 also contains adapters for mounting in
non-HP racks.)
1. Remove the strap handle on the IF-Display section’s left side
panel.
2. Remove the right-rear lock foot, and the right-rear top foot from
the IF-Display section. Slide the right-side cover off to the rear.
Install the right-side cover included in the kit, and replace the
rear feet.
3. Remove the front-handle trim from each side of the RF and
IF-Display sections. See callout 1 in Figure 2-8.
Figure 2-8. Removing the Handles and Trim
4. Remove the three screws securing each handle, and remove the
handles. See callouts 2 and 3 in Figure 2-8.
Installation 2-13