Specifications

To Install Standard

1. Place the RF section right-side up on a level work surface.

Instruments

2. Place the IF-Display section on top of the RF section, offset far

enough forward to allow the RF section hooks to engage the

IF-Display section frame when slid back. Slide the IF-Display

section back until the RF section hooks catch the bottom of the

IF-Display section.

3. Line up the rear-panel lock feet, and tighten the thumb screws on

both lock feet.

4. Connect cable W31 between IF-Display section

and RF section

J6. See Figure 2-l.

5. Connect cable

W30

between IF-Display section

and RF section

Jl.

w30

w31 w37

W38

J4 J5

Figure

1. Rear-Panel Cable Connections

6. Determine the ac line voltage to be used.

7. On each instrument section, slide open the power module’s fuse

cover (located on the rear panel). See Figure 2-2. Push the

fuse-pull lever to the left. Remove the fuse.

2-4 Installation