Specifications

Figures
l-l. HP 8568B with Accessories Supplied
.........
1-2. AC Power Cables Available
.............
l-3. Typical Serial Number Label
............
1-4. Static-Safe Workstation
...............
1-5. Display Bezel Screws
................
l-6. Removing the Bottom Cover
............
1-7. Location of Al5 Controller Assembly
........
l-8. Location of Battery on Al5 Controller Assembly
...
1-9. Factory Packaging Materials for Each Section
.....
2-l. Rear-Panel Cable Connections
............
2-2. Voltage Selector Board and Fuse
...........
2-3. Removing the Handles and Trim
...........
2-4. Removing the Information-Card Tray
........
2-5. Attach the Rack Mount Flanges
...........
2-6. Voltage Selector Board and Fuse
...........
2-7. Rear-Panel Cable Connections
............
2-8. Removing the Handles and Trim
...........
2-9. Removing the Information-Card Tray
........
2-10. Attaching the Rack Handles and Flanges
.......
2-l 1. Rear-Panel Cable Connections
............
2-12. Voltage Selector Board and Fuse
...........
2-13. Attaching the Inner-Member Brackets
........
2-14. Slide Adapter for Non-HP System Rack Cabinets
...
2-15. Removing the Bottom Cover
............
2-16. Location of Al5 Controller Assembly
........
2-17. Address Switch (Shown in Factory Preset Position) . .
2-18. Address Switch Set to 4
...............
3-l. Instrument Dimensions with Handles
........
3-2. Instrument Dimensions without Handles
.......
4-l. Typical Spectrum Analyzer Resolution
........
4-2. Single Sideband Noise Normalized to 1 Hz BW versus
Offset from Carrier
...............
4-3. Typical Sensitivity vs. Input Frequency
.......
4-4. Typical Optimum Dynamic Range
..........
5-l. Dual Bus (MTS) System Connection
.........
5-2. Single Bus System Connection
............
5-3. RF Input and Calibration Controls
..........
l-3
l-4
l-8
l-10
1-12
l-14
1-15
1-16
l-20
2-4
2-5
2-7
2-8
2-9
2-10
2-11
2-13
2-14
2-15
2-15
2-16
2-17
2-18
2-21
2-22
2-23
2-24
3-19
3-19
4-1
4-2
4-3
4-4
5-6
5-6
5-9
Contents.5