Specifications

19
• Millimeter Module Cable Options ( for N5261A and N5262A Millimeter Test Set
Controller)
• Option 501: A set of 4 foot cables for connection of a module to the test set controller.
• Option 502: A set of 2 meter cables for connection of module to the test set controller.
• Option 503: A set of 3 meter cables for connection of module to the test set controller.
• Option 505: A set of 5 meter cables for connection of module to the test set controller.
• Millimeter-wave modules with bias-tees (Option 017)
(Only available with the PNA N5250C)
Adds 67 GHz bias-tees to the combiner assembly between the input to the combiner
and the 67 GHz coupler. The bias-tees have tri-axial connectors for force, sense,
and ground. Positioning the bias-tees close to the DUT greatly improves stability for
on-wafer and in-fixture devices. The bias-tees added for this option have a voltage
rating of 40 volts and a maximum of 0.5 amps.
• Millimeter-wave modules with bias-tees and port 2 attenuator (Option 018)
(Only available with the PNA N5250C)
Adds 67 GHz bias-tees to the combiner assembly between the input to the combiner
and the 67 GHz coupler. The bias-tees have tri-axial connectors for force, sense,
and ground. Positioning the bias-tees close to the DUT greatly improves stability for
on-wafer and in-fixture devices. The bias-tees added for this option have a voltage
rating of 40 volts and a maximum of 0.5 amps. Additionally, Option 018 adds a 25 dB
micrometer attenuator to the port 2 test head.
• IF access (Option H11)
Provides hardware to enable antenna, point-in-pulse, and broadband millimeter-wave
measurements to 110 GHz. For each of the MW PNA’s measurement receivers, IF gates
(enabled with pulsed measurement capability, Option 008) and external IF inputs are
added.Inaddition,accesstothePNA’sinternalRFandLOsourceisprovidedforremote
mixing applications. For basic antenna measurements, only Option H11 is necessary.
Pulsed-antenna applications also require the pulsed measurement capability (Option
008). Broadband measurements to 110 GHz, also requires an N5260A.
◦ Use external IF access for up to 20 dB more sensitivity when making antenna
measurements with a remote mixing configuration
◦ Add Option 008 (Pulsed-RF Measurement Capability) to enable advanced pulsed
measurements
◦ Upgrade an E8361C with Option H11 to a broadband (10 MHz to 110 GHz) VNA system
simply by purchasing an N5260A controller test set with Option 110, 120, or 130.
• Time-domain capability (Option 010)
Used for viewing reflection and transmission responses in time or distance domain.
• Configurable test set (Option 014)
Provides six front panel access loops. The loops provide access to the signal path
between (a) the source output and the reference receiver, (b) the source output and
directional coupler thru arm and (c) the coupled arm of the directional coupler and the
port receiver.
• Extended power range and bias tees (Option UNL)
1
A 50 dB step attenuator and bias-tee set is inserted between the source and test port
one and another set between the source and test port two.
• Frequency offset (Option 080)
1
This option enables the PNA Series microwave network analyzers to set the source
frequency independently from where the receivers are tuned.
1. These options apply to the E8361C and are
limited to 67 GHz frequency range.
Option Descriptions