Service manual

8510XF Network Analyzer Systems 3-27
Operation
Standard Types
Full 2-Port Isolation
Standards
These standards are used to measure forward and reverse isolation for full
2-port calibrations. When you perform a calibration of that type using a
1.0 mm calibration kit, you will see the following menu:
Figure 3-15 Full 2-Port Isolation Calibration Menu & Equivalent GPIB Commands
Notes on the Standards {FWD ISOL’N
LOAD}
Refer to “Isolation” under “Banded Standards” in
Table 3-1 on page 3-12.
{REV ISOL’N
LOAD}
Refer to “Isolation” under “Banded Standards” in
Table 3-1 on page 3-12.
NOTE To skip the isolation part of the calibration, select {OMIT ISOLATION}.