Service manual

3-16 8510XF Network Analyzer Systems

Operation

Calibration Types

S11 1-Port This calibration is for reﬂection measurements using the left test port (within

those operational limits, however, it is a thorough and accurate calibration).

To perform this calibration using the 1.0 mm calibration kit, select:

[CAL] {CAL1 or CAL2} {S11 1-PORT}

This calls up the following menu:

Figure 3-5 S11 1-Port Menu & Equivalent GPIB Commands

For notes on the three types of standards involved in this calibration, see the

following:

• “Open/Short Standards” on page 3-21

• “Shorts Standards” on page 3-22

• “Load/Short Standards” on page 3-23

S22 1-Port This calibration is for reﬂection measurements using the right test port

(within those operational limits, however, it is a thorough and accurate

calibration). To perform this calibration using the 1.0 mm calibration kit,

select:

[CAL] {CAL1 or CAL2} {S22 1-PORT}

This calls up a menu which is identical to the one shown in Figure 3-5

above, except that it is identiﬁed as S22 rather than S11.